Gastroback 41403 Instructions d'exploitation télécharger pdf (Page 20)

Do not leave any food dry up on the appliance or any parts of it to prevent a build up of

dried-on foods. Always clean the appliance after each use according to the following inst-

ructions.

Disassemblingtheappliance

WARNING! Always switch off the ON/OFF button and power switch, wait until the

motor comes to complete standstill, and unplug from power outlet, before disassembling or

cleaning the appliance.

1. Switch off the ON/OFF button and power switch, wait until the motor comes to complete

standstill, and unplug from power outlet.

2. Remove the pusher. Then lift the tablet upwards to remove it.

3. Grasp the cutter housing with one hand, then press the release button near the gear hole

in the front plate of the appliance. (See: ›Knowing Your Design Mincer Plus‹)

4. With the release button pressed, unlock the cutter housing by turning it clockwise. Then

pull the cutter housing out of the motor housing.

5. Unscrew the screw ring.

6. Hold the cutter housing close over a plastic bowl or kitchen sink and carefully turn the

cutter housing with the outlet downwards. This way, the parts within the cutter housing will

fall out. Possibly, for this you must impress the gear of the worm shaft in the cutter housing.

Cleaningtheappliance

WARNING: The edges of the cutter blade are very sharp. Handle with care to avoid

injuries.

Do not use any abrasive cleaners, cleaning pads (e.g. metal scouring pads), or any corrosi-

ve chemicals (e.g. bleach) for cleaning the appliance or any parts of it, to avoid damage to

the surfaces. Do not immerse the motor housing or power cord in water or any other liquid.

Do not spill or drip any liquids on the motor housing, or on the power cord to avoid risk of

fire and electric shock. Do not use violence!

Donotplacetheapplianceoranypartofitinanautomaticdishwasher!

1. Clean pusher, tablet, cutter housing, worm shaft, and screw ring, as well as any used tools

with warm dish-water and a nylon brush. If there are any tools within the pusher, take the

tools out first. Stubborn residues on the surfaces can be removed better by soaking in warm

dishwater for some minutes.

2. Moisture a clean cloth or soft sponge with a little warm dishwater and carefully wipe the

exterior of the appliance and the power cord.

WARNING: Always ensure that the appliance and all parts of it are out of reach of young

children.

3. Thoroughly dry the motor housing and all parts, and let dry naturally for about half an

hour out of reach of young children.

4. It is good advice to lubricate the grinding discs and cutter blade with some vegetable oil.

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

Gastroback 41403 Instructions d'exploitation Page 20